Installation instructions
Most of our furniture is shipped whole without bolting. This saves you time and money.
However, if for some reason the furniture must be brought in pieces below are brief instructions:
What do you need?
To assemble our desks, all you need is a cordless drill and screwdriver with two bits: a 1.5mm drill bit and a standard bit.
How long does it take to assemble the desk?
Usually about 10 minutes.
What steps do I need to perform?
Lay the tabletop on the floor with the top side down. It’s a good idea to put some material on the floor beforehand, which will prevent scratching the tabletop during screwing.
Set the metal frame on the tabletop. These are two legs and longitudinal crossbars.
It is necessary to drill holes in the countertop with a thin drill bit. It can be 1.5mm in diameter. Then screw the frame to the countertop with the included screws.
Corner desk
Desks are shipped in two pieces. Assembly instructions:
After unpacking the desk, place the main desk on a stable and level surface.
Slide the extension into the protruding parts of the main desk.
Screw the extension and the main desk together using two screws. For this operation you can use a screwdriver or a screwdriver.
The desk is stable and ready for use.
Desks set on a pedestal
Desks are shipped in two pieces: a desk and a pedestal. The frame of the desk has a metal pin, and the pedestal has a hole in which to embed it. On request, we can make the hole in another place or dispense with the pin.
Installation of drawer, cable grilles
Drawers and cable grilles are screwed directly to the countertop with special screws. It is best to use a screwdriver for this
Assembly of blends
Assembly of a large conference table
Mounting a bed
